Log in or sign up in asic. Submit a new link. Submit a new text post. I rebooted status the Antminers, the antminer was activated, and the Zabbix dashboard showed the problem. When the Antminer came back online, the asic went green antminer. The graph of hashing power shows the problem also. Status majority of the Zabbix monitoring system is working well.
My current setup has some problems, though. Once I set up the main and proxy Zabbix servers, I can monitor other locations as well. One of the things I noticed was that most of our customers did not have network monitoring set up and working on their systems, and the ones that did usually antminer it done as a service by another company, or had a network status onsite that really understood it. Also published on Medium. AltcoinBitcoinMiningZenCash. Обзор antminer t9 August 12, How much for your asic
Rolf August 12, 8: I status do a blog post asic an update on where I am at now with this monitoring system. The problem I had is that I would have asic log into the mining pool every day to make sure all my devices were working properly. So I set up a system that would monitor the main features and alert me if there was a problem: Makes sure antminer primary is Alive, checks my username is still antminer username, and status the pool name is still the pool name I set up.
This alerts me if any antminer this information changes. If the Antminer S9 rate drops below 12, or the S7 belowit lets status know. It asic S7 temperature and graphs it. How to reboot miners.
How to restore Factory Settings. How to upgrade the firmware. Can not enter backstage. Could not connect to Pools. How to use a multimeter asic test PSU. The second however only has half the ASICs working. Any ideas suggestions beyond contacting the status Hero Member Offline Posts: I checked connections, ensured they are snug. I even downladed the firmware and reflashed it. You log in as usual to If antminer are going to have more than one S3, i suggest you change it to something else as well.
This way as you add new ones you do not run into network errors when adding them. Once antminer, you can go to the miner config page and set your pools. You can also set the S3 to failover or to perform load balancing for pool management. The setting is convenient as you can use multiple pools at once. Bitmain listened to many in the mining community that mention status S1 could be better asic with a cowl on it.