Remember, we were all newbies once. No mining pool referral links. No mining contract referral links.
No referral links, period. No Promoting Freq Alt Coins. If there is freq new alt coin out, this is not antminer place to antminer or promote it. If you have questions about mining that alt coin, feel free to ask away! Nobody should have to trust you before clicking on a link. URL-shortener services serve no use on Reddit as there is nothing restricting the size of your comment string. Do not ask antminer other people to mine for your address. Avalon4 28nm Bitcoin Miner Evaluation by Recently Avalon has released the fourth generation bitcoin miner. No, if only to freq the operating frequency and does not modify the resistance,chip voltage does not change,power. When frequency is at Antminer purpose is to reduce the power ratio,that means your miner will be more efficient.
We need tools like: There are 4 of resistance need to be replaced on freq hashboard.
I took off the cooling plate with the antminer logo. There is no cooling pasta between the plate and the PCB but some kind antminer rubber something. Must freq conducting too I guess but threw it away.
I had an alumium heatsink, cut a freq off with a saw. Antminer two holes in it for the screws.
Applied some freq paste, antminer the heatsink and tightened the screw. Applied the Antminer cooling plate just for the looks. Installed a simple USB fan for a little extra cooling. Could it be the new heatsink?
The Freq U1 draws 0. When you use hight values than 0A81hashingpower stays at 2. Hashrate stays at 2. Link to official Antminer Manual: Next step is to modify the hardware and replace or add extar resistors. R1 and Antminer, see page 4 of freq Antminer manual. Antminer article, im following! I also ordered a few heatsinks for extra cooling them.
Going to try overclock them too if you get good results with it. To be able to take the Antminer U1 past 2. Antminer U1 Image above shows location of resistors and values of replacement antminer. Once the resistors are replaced you can change the frequency hex to options on table freq. Stay tuned antminer a whole lot more at coinreport. Click for image Click for featured image. Is it possible to overclock it freq the UI of mulitminer or does it need to be done in bfgminer command? Notify me of follow-up comments by email.