Antminer document your print and share a Make with the community. Click the button below and you will be redirected to PayPal. Tip Designer Report Thing. Liked By View All.
Give a Antminer apw3 Out. Summary Its pretty simple a MM to 4 Inch duct. If you need a bunch them right now I sell them on E-Bay check out my store here. It is just as antminer to have it all on antminer bottom. Legs took me some time to get the height properly so that the fan can take in enough air.
Legs are not necessary and your miners can be horizontal, if you wish.
I was following the natural motion of the hot air so I prefer having antminer vertical. Leg, screw and the fan are shown in the picture: On the top image you can also see how I screwed in the fan to the miner, having the fan duct stuck in the middle. Screws are screwed in by hand and then just tightened a little bit with the tool on the picture: This is the bottom fan duct: It is designed to force the most air into the main heatsink, with little gaps letting the air through to side heatsinks and thermistors.
The only reason for this is to force the air to move around external heatsinks and affect the thermistor. The fan duct perfectly fits the miner on one side and a mm fan on the other. They were sticking out too much and antminer duct would have 2mm gap from the miner.
The top fan duct is different, featuring no side gaps: It also perfectly fits the miner. The fan screws on top just as easy as it antminer with the bottom duct: You want the screws to be positioned like this: Take your screwdriver and start screwing it in. In the end it will just fall in. You will probably antminer a tiny bit of plastic, but not enough to void warranty or anything like that.
I had one of the fans going back under warranty because of excessive vibration. Got a new one back antminer a problem.
The end antminer is something like this: The older miner with bigger gap between heatsinks and custom external heatsinks: The newer green plastic miner: Here you can download all of the STLs for the 3D printed parts: If you have any questions, do not hesitate. Hero Member Offline Posts: Could you plug them like that and give us some data temp, hash etc. Do note that this is an experimental custom firmware and using it might void your warranty. Also note that it comes with built-in 1. Hi all, I am thinking about taking the leap into bitcoin mining but first I wanted some advice from others who already partake in this.
I have done my research and the only information that I cannot seem to find is whether or not it antminer s7 wiki still profitable to mine for bitcoin or other cryptocurrencies, because all of the articles on this subject are from Does anyone mine for themselves and is it still profitable? Ali Take 3 seconds to use Google instead of being lazy. I have an Antminer D3 and have been using this firmware.