Antminer firmware upgrade

How to restore Factory Settings. How to upgrade the firmware.

Antminer D3 Blissz firmware (10/12 v update)

Upgrade to use a multimeter to test PSU. D3 Different Version Comparison. When are you waiting for a new batch? Предзаказ на сентября? Что antminer с курсом криптовалит? Firmware будут новые или после работы? If you would like to receive D3 notification email, please leave a message here or create a ticket via https: Thank antminer Sarah Li. I have sent many messages to he upgrade to notification list of new stock.


Antminer D3 – Bitmain

If we could add item to basket before it would be easier. Sarah Li - December 28, Edited by Kaxagugrsha July 22, I would like to know when the next batch will be available. When the new batch going to be available. What does that mean Niki or BIll? Following for new batch.

Antminer Firmware Updates

Edited by Tiernan Quinn July 25, November 01,upgrade Download the custom firmware. After flashing, check antminer advanced settings page and start at the lowest voltage setting and antminer. From there increase your firmware to see how high you can go at the lowest voltage setting. Start tweaking some more. Firmware the profile suggestions below. Manual mode is for setting a static fan speed. So flash at your own risk and please use the firmware wisely.

Some startup settings to get you going: Upgrade slowly increase the frequency until you see HW errors.

Asic Bitcoin Mining Hardware From Bitmain

When you have a few HW errors an hour you found the sweet spot set the fan speed manual somewhere between 20 - 30 percent. Chip temp should be somewhere between 75 - 80 degrees max.

antminer firmware upgrade

For stock performance at lowest possible power usage Expected hashrate: Now decrease the voltage antminer you see HW errors. When you have a few HW errors an hour you found the sweet spot Back to bitmain stock firmware: In case you want to go back to the original firmware: The miner webinterface antminer come up again.

Hero Member Offline Posts: The money raised from these ads will be used to pay for improved forum software and other useful stuff. I successfully modded the firmware which will add unlocked voltage and fan control, so Upgrade advice NOT to hardware mod upgrade see how far antminer s7 f1 can go with the firmware mod. If you want firmware undervolt more I advice the firmware mod.

antminer firmware upgrade

To get there I tried to reverse antminer the upgrade circuit of the antminer D3 mining boards. So I tried changing the resistors around it and found out that antminer the resistor R80 controls the voltage. Woop Woop So if you want to do the mod I advice to upgrade R80 by a 25k ohm potentiometer. The voltage can be firmware over C Improvement: It also allows to increase the voltage for overclocking if you firmware to do so.

But overclocking is not my goal, I wanted a silent miner: Therefore I now run my boards 7. I will make new higher res zoomed pics soon.

Похожие статьи:

  • Эстонская компания diamond antminer
  • Обзор antminer asic d3
  • Antminer s4 miner
  • Rx 570 armor 4g oc майнинг

  • Рекомендуем почитать:

  • облачный майнинг antminer
  • - 2018 (c)