Since I got the first one I average around 30 HW errors every 24 hours. Chip temp is important but ask yourself what adjusting the frequency actually does and why this causes the miner to draw more power.
Can they handle it? The most likely scenario is that the chips were initially tested during design to see how high the frequency could be pushed before failure starts to occur. Too me, I think its worth it. But I can also see it your way as well. Some do not want to add more risk into an already risky equation Your most likely culprit is power. I would swap power leads from one of the good boards to the non-working board and see if it starts reporting.
Board confirmed to be dead. Sending back to Bitmain.
Hero Member Offline Posts: Why does no one READ the very top thread in this section? You posted this in the Bitcoin section and that is an altcoin miner. Betcha the mods move this to here where it belongs Other than that, well done.
Globegains on August 03, Mining pool - AntPool. Hawker on August 03, Full Member Offline Activity: Over clocking of antminer will void your warranty.
Should at least wait until your warranty expires after days otherwise its a big gamble. Yes well worth the extra power use. I ordered from Bitmain back in April and just received the miner earlier this week.