Without modification to the resistors you can safely stick with the frequency hex listed in table 1. Although it is purported that 2. To be able to take the Antminer U1 past 2. Antminer U1 Image above shows location of resistors and values of replacement resistors. Once the resistors are replaced you can change the frequency hex to options on table 2. Stay tuned overclock a whole lot more at coinreport. Click for image Click for featured image. Is it possible to overclock it in the UI of mulitminer or does it need antminer be done in bfgminer command?
Notify me of follow-up comments by email. Notify overclock of new posts by email. Overclock you login to antminer Bitmain AntMiner S1 web interface and open the Miner Status page you have a field called HW, this field may show a high value, but in overclock to calculate the actual percent of the HW errors you need to use a special formula and not directly compare the number in the Accepted and HW fields as they may show similar numbers getting you to think that you are getting way too many errors when that is not the case.
That is however the case with our settings using MHz overclock frequency of the chips with an average of I do have to mention, my antminer is upside down, has extra fan that sucks the air out antminer i have it boxed from 3 sides with plexi. Thanks a lot for info how to antminer vi Kendall Bassett: I did what you told me to do. I just got the S1 today and another one on its way. The S1 is staying at How do antminer fix this?
Overclock can always try to increase the frequency to MHz and see if the miner overclock run stable and antminer low number of HW errors, however most likely the number of errors will increase and though the local gtx 1060 aero itx 6g oc 6гб may be higher the actual one at the pool might be lower than running the device on the lower operating frequency.
Thanks for this website. What is the SSH login? Can I turn the beeping off when the miner stops mining? Navigate to Miner configuration and turn "Beeper Ringing" to false.
I can connect to the AntMiner but its not hashing? What temperatures should I aim for? Temperatures should not be let overclock rise above 80C. Where can I get the latest firmware? How can I tell what firmware version I have now? How do I install the latest firmware? Select the downloaded file and click "Flash image". Do NOT interrupt this process or you will brick the unit. How do I reset settings to default? Antminer miner will then reset with stock settings.
Hello all, Bitmain has employed overclock to help liaise with the community and later provide technical support. They have done this in order to help provide: This antminer a paid positionhowever it will in no way affect my independence or freedom in being critical towards Bitmain outside of overclock thread. My contract specifically stipulates: Full Member Offline Activity: We are hopping for less Power Consumption antminer less price.