You need to be in directory where your image is located or you need to write complete path to your image firmware last command. Process is pretty straightforward and easy to do. First insert your microSD antminer in your card reader.
Check in my computer that your card is present and healthy. Firmware is the picture showing the sd card: If the hashing power seems to be affected, please check your PSU and wiring and reboot and check the status a few times. We have encountered such issue when testing, there are some "x" showing on the ASIC chip status, like the following picture showing: Then, we restarted the miner, and the "x" disappeared.
Antminer Antminer Antminer Bitcoin Antminer. Bitmain Antminer U3 - Degree View. Avalon Avalon6 - Firmware View. Bitmain Antminer S4 Setup Guide. The S4 is standalone and does not require an external controller. Please note that in order to start the unit, you must press and hold the push button on the back of the power supply.
All four are automatically controlled antminer the software and react to increased temperatures. The fans spin at maximum RPM which is loud, antminer видео are loud due to the shear volume of air displaced as opposed to annoying tones. The rear of each hashing board is covered by a full cover aluminium heatsink, and the front by firmware curved finned heatsinks over the chips. Please be careful when handling these heatsinks, they are extremely sharp.
The aluminium case is held closed by 6 screws placed on the top for easy access. Please be careful when replacing the case lid, that you make sure the grill on the lid is aligned with the PSU, else the PSU will be suffocated and may overheat.
PreludeMar 13, Smit I know your working on other things do you think you can get the voltage fix on the firmware for us. Thanks in advance keep up the good work. Hi the above link Code: SD is now dead is there anywhere else this is available from??
Then, I have a request: Can you, please, update your package with the latest one from Bitmain initramfs. There has been started a development of firmware for AntMiners from scratch. Ants to be supported by this FW: The new firmware contains the firmware 4. With the shipped firmware on batch one, you will find that many times the hash rate will not report correctly, and poolside will only show up as less than half or less of the total hash antminer.
Make sure to set the difficulty to on your pool. Right now BTCGuild works the best. Ghash and eligius work but not up to full speed with the newest firmware.
We were not able to get it to firmware well with P2Pool. NastyPool gave me the best results at roughly 1. The driver needs to be fixed to allow better compatibility and currently ckolivas of cgminer is working on better cgminer results but is antminer Bitmain to fix their driver. The Antminer S4 pulls watts at the wall while running at 1.