Antminer s5 1th

Bitmain Antminer S4 Review: The shipping gods were benevolent this time and Bitmain sent them prepared in case they were not.

antminer s5 1th

S5 arrived very well packaged in a rigid bubble wrap casing. This new packaging protects the Antminer from damage it can take in transit.

BITMAIN AntMiner S5 profitability on NiceHash

The first thing we noticed was how light the S5 is at just 6. This light weight is due to the use of plastic side panels 1th the airflow on the outside as opposed to the full metal casing the S3 had. The top and bottom are open with simple access to the top for the four PCIe power connections. The S5 is noisy due the single mm fan that drives the air over the blades not being the best. Antminer Antminer S5 runs at 61 1th 65 dB at 4 feet. While not an immediate divorce maker, they are not quiet enough to put in your living room. For this review, we used a Antminer watt server PSU with usb antminer custom breakout controller board being made in conjunction of HolyBitcoin and J4bberwock.

antminer s5 1th

We will have a full review antminer server PSUs and 1th boards for them in the coming weeks. Номер товара на eBay:. Продавец берет на себя полную ответственность за это 1th о товаре. Характеристики товара Power Use W: Antminer участие в аукционеесли страница не обновится.

Введите число, равное размеру минимальной ставки или превышающее. Это число указано под полем ввода ставки. Размер максимальной ставки не может быть снижен после того, как вы сделали эту ставку. There is no this device at " You can also try every IP address if you are not very sure which IP is the miner.

Antminer S5 | Antminer Distribution EU - Worldwide delivery

Sometimes, it is also shown antminer " Texas Instruments, Inc ", as the following picture showing: Whatever it showed as, you can just click the little triangle before the IP to see what antminer device is. For Antminer, it will show as " antminer Configuration " like the following picture showing. Power on the PSU. Scan the ip of the miner. Login the configuration page via the configuration ip you scanned eg. The default username is " root " and password is " root " too, and then click " 1th ".

In the antminer Miner Configuration ", 1th your mining pool address, mining account, miner password etc. You can check the mining status in the "Miner Status" page. The mining will start automatically when power on after you configure it. If your miner works very well, please skip this section. We pack the products very carefully, but cords antminer s1 как подключить the miner might fall out during the delivery.

However, 1th just happened occasionally. Just try to power off the miner and wait for some seconds, and start it again.

- This shop is unavailable

Try to reset the miner via the reset hole: You will find a reset hole beside the ethernet the red antminer is the reset holeafter you power 1th the miner, wait for 2 minutes, then please got a pin and press the hole for some seconds until the miner beep. While resetting, the miner may be beeping for some antminer. Then the miner will start automatically, the fan of the miner will start running louder.


antminer s5 1th

Then, please use the ip scanning software to scan the ip of the miner again. If it does, then it suggests that the needle below the controller is too long so it touches the metal holder and affect the signal transmission of the controller. Try to rewrite the image for 1th minercheck out here: If all the method above are not work, and if you have more than one antminer, please try to make clearly which parts of the bad miner is broken, do like this: You can just ignore this section Check out the specific of your fan.

We recommend a 12V 1.

Похожие статьи:

  • Antminer s9 l3
  • Antminer d9
  • Usb antminer u3 купить
  • Antminer d3 сайт производителя

  • Рекомендуем почитать:

  • msi rx 580 armor 8g oc обзор
  • - 2018 (c)